高頻電路實習

臺北科技大學 114-2 學期課程，課號 354408。

課程大綱

1. 阻抗匹配器 2. 濾波電路 3. 小訊號放大器 4. 弦波訊號產生器 5. 晶體振盪器 6. 混波器 1. Impedance matching circuits 2. Filters 3. Small-signal amplifiers 4. Sinusoidal wave generators 5. Crystal oscillators 6. Mixers

課程進度

Week 1: Course content introduction Week 2: Simulation tool teaching Week 3: band-pass filter (BPF) introduction (ex: duplexer in FDD) Week 4: band-pass filter (BPF) design teaching (transmission line, S parameters) Week 5: band-pass filter (BPF) design teaching (Smith chart, EM simulation) Week 6: band-pass filter (BPF) implementation (PCB layout tool teaching) Week 7: Qingming Festival Holiday Week 8: Project-I BPF examination Week 9: Receiver (Rx) introduction (ex: Rx specification) Week 10: low-noise amplifier (LNA) design teaching (DC bias circuits, noise matching) Week 11: low-noise amplifier (LNA) design teaching (power matching, small-signal stability) Week 12: low-noise amplifier (LNA) implementation (all components are on PCB) Week 13: Project-II LNA examination Week 14: Transmitter (Tx) introduction (ex: Tx specification) Week 15: power amplifier (PA) design teaching (DC bias circuits, load pull, efficiency) Week 16: power amplifier (PA) design teaching (source pull, large-signal stability) Week 17: power amplifier (PA) implementation (all components are on PCB) Week 18: Project-III PA examination

評量方式

實作一 Project I (BPF) : 30% (成品佔20%, 口試佔10%) 實作二 Project II (LNA) : 35% (成品佔25%, 口試佔10%) 實作三 Project III (PA) : 35% (成品佔25%, 口試佔10%)

教材

【遵守智慧財產權觀念，請使用正版教科書，不得使用非法影印教科書】 使用外文原文書：是 RF Circuit Design Theory and Applications by Reinhold Ludwig and Pavel Bretchko